Eks 314 Maintenance Checklist - Jungheinrich EKS 314 Manual De Instrucciones

4

EKS 314 maintenance checklist

Chassis/ 1.1 Check all load bearing components for damage
Structure:
1.2 Check screw connections
1.3 Test the operator's platform and check for damage
1.4 Check that identification points, data plates and warning
1.5 Check tilt safety devices are present and secure
1.7 Make sure decals are present, legible and valid
1.8 Check battery panel and sides are secure
1.9 Test battery panel attachment and check for damage
Drive: 2.1 Lubricate the bearing between the drive motor and
2.2 Check transmission for noise and leakage
2.3 Change transmission oil
Wheels: 3.1 Check wheels for wear and damage
3.2 Check and lubricate bearing and attachment
Steering: 4.1 Test operation and setting of wheel position display
4.2 Check the distance between the guide rollers and the
Brake sys- 5.1 Test operation and settings
tem:
5.2 Check the brake lining wear
5.3 Check brake mechanism, adjust and lubricate if
labels are legible and replace if necessary
transmission
rail guidance over the entire length of the rails. The play
between the two guide rollers and the rails (measured
over the axle) should be 0-5 mm/0-0.2 inches. The roll-
ers should not jam.
necessary
Maintenance intervals
t
Standard = W A B C
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
G 7