Jungheinrich EKS 314 Manual De Instrucciones página 90

Lift mecha- 10.1 Clean contact surfaces in the mast sections and apply
nism:
10.2 Check mast attachments (bearings and retaining
10.3 Check lift chains and chain guide for wear, adjust and lu-
10.4 Lubricate lift chains
10.5 Visually inspect rollers, slide pieces and stops
10.6 Check forks and fork carriage for wear and damage
10.7 Check pallet clamp for wear and damage
Safety 12.1 Check operator safety harness + belts for damage and
Devices:
12.2 Check safety harness retaining point for for damage and
12.3 Check legibility of notices on safety restraint belt.
Lubrication: 13.1 Lubricate the truck according to the lubrication schedule
General 14.1 Check electrical system for frame leakage
Measure-
14.2 Test travel speed and braking distance
ments:
14.3 Test lift and lowering speeds
14.4 Test safety devices and cutouts
14.5 IG: Measure the current in the guidance wire, adjust if
14.6 Check travel on the guidance wire, check maximum de-
14.7 Check tracking mode on the guidance wire for aisle
14.8 Check wire guidance EMERGENCY STOP operatione)
Demonstra- 15.1 Test run with rated load
tion:
15.2 When maintenance is complete, present the truck to the
e) IG: inductive guidance trucks
grease.
IMPORTANT Attention: Secure Mast as necessary!
screws)
bricate
wear, and test operation
wear, and test operation
necessary
viation and adjust if necessary
tracking
responsible person.
Maintenance intervals
t
Standard =
e)
e)
e)
W A B C
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
G 9