Features And Specifications; Technical Features - SEA MARK TANK E 270 Manual De Instalación

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888

FEATURES AND SPECIFICATIONS

The MARK TANK E 270 and MARK TANK E 390 are two high quality hydraulic operators for residential and condominium use with
leaf length up to respectively 3 and 5 m.
Available in the following versions:
SC (with lock only in closing)
SB (without lock)
SA (with lock only in opening)
AC (with lock in opening and closing)
The lock is guarantied on leaves with lengths under 1,80 m with the MarkTank E 270 operator while for lengths up to 2.20 m use the
Mark Tank E 390. An electric lock should be used for leaves (in all versions) exceeding those lengths.
The Mark Tank E is supplied with by-pass valves for the power regulation in both opening and closing. Electronic adjustable slow
down in opening and closing with electronic control board. For the European laws and directives actually in force it is strongly
recommended to use the Safety Gate (device for the reading of the gate position), for reverse in case of obstacle.
Fig. 2
1
2
4

TECHNICAL FEATURES

Power supply
Power
Absorbed current
Stroke
Rod speed
Cycles hour (at a temp. of 20°C)
Max working pressure
Operating temperatures
Thermal protection
M ax Thrust
Capacitor
Weight
P rotection class
Max leaf lenght
Opening degree of the leaf
Note: The frequency of use is valid only for the first hour at 20°C room
temperature.
2
67410019
®
Fig. 1
3
MARK TANK E 270
230 V (±5%) 50/60 Hz
180 W
1 A
270 mm
1,2 cm/s
40
30 bar
-40°C
130°C
250 daN
12,5µF
10,5 kg
Ip55
3 m
90° - 110°
0
9
1. Shaft cover
2. release
3. Front bracket
4. Rear bracket
5. Cylinder
6. By-pass valves
7. Electric motor
8. Hydraulic pump
9. Exit electric cables
MARK TANK E 390
220 W
50
40 bar
+60°C
640da N
12 kg
5 m
REV 00 - 07/2013
Dimensions (mm)
0
7
5
6
5 m
3 m
OPERATORS
40
50
MARK TANK E
English English
7
8
9