Installing The Platter, The Scratch Disc And The Slipmat / Connections - Denon DN-S3500 Instrucciones De Operación

ENGLISH
INSTALLING THE PLATTER, THE SCRATCH DISC AND
2
THE SLIPMAT / CONNECTIONS
(1) INSTALLING THE PLATTER, THE SCRATCH DISC and THE SLIPMAT
• Accessories
q Aluminum Platter..............................................1
w Scratch Disc......................................................1
e Slip Mat ............................................................1
r Adaptor (1) ........................................................2
(One is for spare parts.)
Scratch Disc
Fig. 1
Slip Mat
(Groove side
DOWN)
Platter
Taper Boss
(Motor Unit)
CAUTIONS:
• Do not touch the motor unit.
• Do not turn on the power without Platter.
1. Install the Platter on the taper boss of the motor.
2. Install the Slip Mat on the Platter.
3. Insert D hole of the Scratch Disc on the D shaft of
the Motor.
NOTE: The printed face is located on the Slip Mat
side.
4. Insert the Adaptor according to the direction of the
arrow.
NOTE: Please note the direction of insertion.
Scratch Disc
Fig. 2
Adaptor (1)
D shaft
Fig. 3
NOTE:
Please note the fall of Platter when you move DN-
S3500 after Platter is set.
(2) CONNECTIONS
1. Turn off the POWER switch.
2. Connect the RCA pin cords between the DN-S3500 outputs and inputs of your mixer.
3. If your mixer has Fader Start function such as our DENON Mixer, connect FADER jack to the mixer using 3.5
mm stereo mini cord.
DN-X300
L L
L R
LINE1
(3) INSTALLATION
Please set up DN-S3500 horizontally.
(4) INSTALLING THE 7" (17cm) RECORD ADAPTOR
Your own 7" (17cm) vinyl record can be installed on this product by using the provided adaptor.
This original design grants you the freedom to use your favorite vinyl record for that ultimate analog turntable
Adaptor (1)
feel.
*Make sure the record used is flat and not warped.
• 7" (17cm) record adaptor accessories
q Adaptor (2) ........................................................1
w Screw (< head) ................................................3
e Fixing Plate .......................................................1
1. Set Adaptor (2) in the hole of 7" record.
2. Fix Plate with 3 screws. (< head).
3. Insert D hole of the Adaptor (2) on the D shaft of the
Motor.
4. Insert the Adaptor (1) on the Adaptor (2).
Fig. 1
Screw (< head)
Fixing Plate
Adaptor (2)
2
ENGLISH
L L
LINE
DIGITAL OUT
L
R
OUT
L
R
FADER LINE OUT IN OUT
MEMO
FADER
FADER
PGM 1
Fig. 2
Adaptor (2)
7" (17 cm) record
NOTE:
Depending on the RECORD you choose, friction
with the Slipmat may not be enough, which can
cause an undesired drag sound.
If so, use a different record that's thicker or
heavier.
POWER ON OFF
7" (17cm) Disc
Adaptor (1)
Slip Mat