Maintenance And Cleaning; Introduction; Nibp Monitoring - Gima CMS8000 Manual Del Uso

SpO COMM STOP
2
SpO COMM ERR
2
SpO ALM LMT ERR
2
PR ALM LMT ERR
Prompt message (include general alerts):
Message
SpO EXCEED
2
PR EXCEED
SEARCH PULSE
NO PULSE

12.7 Maintenance and Cleaning

Care and Cleaning
Warning
• Turn off the monitor and disconnect the line power before cleaning the monitor or the sensor
• Do not subject the sensor to autoclaving.
• Do not immerse the sensor into any liquid.
• Do not use any sensor or cable that may be damaged or deteriorated.
Cleaning:
• Use a cotton ball or a soft mull moistened with hospital-grade ethanol to wipe the surface of the sensor,
and then dry it with a cloth. This cleaning method can also be applied to the luminotron and receiving unit.
• The cable can be cleaned with 3% hydrogen dioxide, 7% isopropanol, or other active reagent. However,
connector of the sensor shall not be subjected to such solution.
Chapter 13

nIBP MonItorInG

13.1 Introduction

• Reference to the European standard EN 1060-1: Specification for Non-invasive sphygmomanometers
Part 1, General requirements.
• The Non-invasive Blood Pressure (NIBP) module measures the blood pressure using the oscillometric
method.
• It is applicable for adult, pediatric, and neonatal usage.
• There are three modes of measurement available: manual, automatic and continuous. Each mode displays
the diastolic, systolic and mean blood pressure.
SpO module failure or com-
2
munication error
SpO module failure or com-
2
munication error
Functional safety failure
Functional safety failure
Cause
SpO measuring value exceeds the range. HIGH
2
PR measuring value exceeds the range.
SpO module is searching for pulse.
2
SpO module cannot detect SpO
2
for a long time.
HIGH Stop using the measuring
function of SpO
biomedical engineer or our
service staff.
HIGH Stop using the measuring
function of SpO
biomedical engineer or our
service staff.
HIGH Stop using the measuring
function of SpO
biomedical engineer or our
service staff.
HIGH Stop using the measuring
function of SpO
biomedical engineer or our
service staff.
Alarm Level
HIGH
No alarm
signal HIGH
2
70
module, notify
2
module, notify
2
module, notify
2
module, notify
2