Total Area /Seed Drill Width - C2 - Sola NS PLUS 2311 Manual Del Usuario

PLEASE NOTE
THE IMPULSE NUMBER AUTO-CALIBRATION MODE IS MORE ACCURATE
AND A FIELD TEST PERFORMANCE IS REQUIRED.
Auto-calibrating the speed sensor
1. Mark 100 metres.
2. Select channel 1 (speed)
3. Press
The screen will display "Auto". Release it.
4. Cover the 100 marked metres. The monitor will count the sensor's impulses.
5. After finishing, press
By doing this, the monitor retains the impulse number in the memory.
10.3 TOTAL AREA / SEED DRILL WIDTH – C2
Two independent total areas can be marked.
Displaying the total area
1. Select channel 2.
2. Press
First, "tot. 1" will be displayed and immediately afterwards the value in Ha
will be shown.
Setting to zero the total areas
1. Select channel 2.
2. Press
3. Press and hold
and hold it while pressing
0/1
Ha 0
again.
to display total areas 1 and 2 on the screen.
to display.
0/1
Ha 0
for more than 5 seconds.
ELECTRONICAL CONTROLLER
0/1
Ha 0
.
61