16- Printer Configuration; 17- Connection To The Pbx; 18- Resetting The Unit - Jusan TAX-LINE Manual Del Usaurio

16- PRINTER CONFIGURATION

This option enables the configuration of the built-in thermal printer.
• Bi-directional: Select ON to increase printing speed.
• Contrast:
• Correction:
• Test:

17- CONNECTION TO THE PBX

Connect the unit to the V24 connector of the PBX. The cable must be plugged into
the 9 pin connector labelled PABX, located on the unit's rear panel.
Pin
2 RXD (Data Reception)
3 TXD (Data Transmission)
4 DTR (Data Terminal Ready)
5 Ground (GND)
8 CTS (Clear to Send)

18- RESETTING THE UNIT

To reset the unit, proceed as follows:
1. Disconnect the unit from the mains, change the position of switch 4 to OFF and
modify the position of switch 3. Reconnect the unit to the mains.
2. Disconnect the unit from the mains again, change the position of switch 4 to ON,
and place switch 3 in the required position, according to the mode you wish to
select. Connect the unit to the mains.
When resetting the unit, all configuration parameters and call records are lost.
Select OFF to improve printing quality.
From 0 (lighter) to 9 (darker) (the default value is 5).
Do not modify.
Print a test page.
Function Direction
To the unit
To PBX
To PBX
To the unit
47
PROGRAMMING