Belkin N1 Vision Manual Del Usuario página 39

Alternate Setup Method
Setting your Internet Service Provider (ISP) Connection Type to Static IP
A static IP address connection type is less common than other connection
types. If your ISP uses static IP addressing, you will need your IP address,
subnet mask, and ISP gateway address. This information is available from your
ISP or on the paperwork that your ISP left with you. Type in your information,
then click "Apply Changes" (5). After you apply the changes, the Internet Status
indicator will read "connection OK" if your N1 Vision is set up properly.
1. IP Address – Provided by your ISP. Enter your IP address here.
2. Subnet Mask – Provided by your ISP. Enter your subnet mask here.
3. ISP Gateway Address – Provided by your ISP.
Enter the ISP gateway address here.
4. My ISP Provides More Than One Static IP Address – If your ISP
assigns you more than one static IP address, your N1 Vision is capable
of handling up to five static WAN IP addresses. Select "My ISP provides
more than one static IP address" and enter your additional addresses.
(5)
37
(1)
(2)
(3)
(4)
1
2
3
4
5
6
7
8
9
10