Belkin N1 Vision Manual Del Usuario página 93

Troubleshooting
2. Unplug power to the N1 Vision for 10 seconds, and then plug the power
back into the N1 Vision. Ensure that the N1 Vision's "router" Display is
on. If not, check to make sure that the AC adapter is connected to the
N1 Vision and plugged into a wall outlet.
3. Ensure that you have a cable connected between (1) the network
(Ethernet) port on the back of the computer and (2) one of the "to Wired
Computers" ports on the back of the N1 Vision.
Note: The computer should NOT be connected to the port labeled "to
Modem" on the back of the N1 Vision.
4. Try shutting down and restarting your computer, then rerunning the
Assistant software.
If the Assistant software is still unable to find the N1 Vision, reference the
section titled "Manually Configuring Network Settings" for installation steps.
Assistant software cannot connect my N1 Vision to the Internet
If the Assistant software is not able to connect the N1 Vision to the Internet,
please check the following items:
1. Use the troubleshooting suggestions within the Assistant software.
2. If your ISP requires a user name and password, make sure that you have
typed in your user name and password correctly. Some user names
require that the ISP's domain may be at the end of the name. Example:
"myname@myisp.com". The "@myisp.com" part of the user name may
need to be typed as well as your user name.
If you continue to have no Internet connection, reference the section titled
"Manually Configuring Network Settings" (page 75 of this User Manual for an
alternative setup method).
91
1
2
3
4
5
6
7
8
9
10