Manually Configuring Network Settings
Set up the computer that is connected to the cable or DSL modem FIRST
using these steps. You can also use these steps to add computers to your
N1 Vision after the N1 Vision has been set up to connect to the Internet.
Manually Configuring Network
Settings in Mac OS up to 9.x
1. Pull down the Apple menu. Select "Control Panels" and select "TCP/IP".
2. You will see the TCP/IP control panel. Select "Ethernet Built-In" or
"Ethernet" in the "Connect via:" drop-down menu (1).
3. Next to "Configure" (2), if
"Manually" is selected, your
N1 Vision will need to be set
up for a static IP connection
type. Write the address
information in the table
below. You will need to enter
this information into the N1
Vision.
4. If not already set, at "Configure:", choose "Using DHCP Server". This will
tell the computer to obtain an IP address from the N1 Vision.
5. Close the window. If you made any
changes, the following window will
appear. Click "Save".
Restart the computer. When the computer restarts, your network
settings are now configured for use with the N1 Vision.
(1)
(2)
83
1
2
3
4
5
6
7
8
9
10