Owner´s Manual
Engine Oil
Engine Oil Level Check
Check the engine oil level each day before riding the
motorcycle.
The oil filler cap/dipstick is in front of fuel tank and
has a dipstick for measuring the oil level. Oil level
must be maintained between the upper (1) and lower
(2) level marks on the oil filler cap/dipstick (3).
The oil level cannot be checked accurately immediately
after the engine has been run at high speed.
Make sure that motorcycle is standing upright on firm
level ground while idling.
1. Park the motorcycle on a firm, level surface.
2. Start the engine and let it idle for 5 minutes.
If the air temperature is below 10°C (50°F), let the
engine idle for an additional 5 minutes (a total of
10 minutes). An engine that is not warmed
sufficiently may give an inaccurate (low) oil level
reading. During idling, support the motorcycle in an
upright position to assure an accurate oil level
reading. Stop the engine.
3. Immediately remove the oil filler cap/dipstick (3) and
wipe it clean.
4. Hold the motorcycle upright. Insert the oil filler cap/
dipstick until it seats, but don't screw it in.
(3)
(1)
(2)
5. Remove the oil filler cap/dipstick. The oil level
should be between the upper (1) and lower (2) level
marks on the oil filler cap/dipstick.
If required, add the specified oil (see page 48) up to
the upper level mark. Do not overfill.
NOTICE
Running the engine with insufficient oil pressure may
cause serious engine damage.
6. Reinstall the oil filler cap/dipstick. Check for oil
leaks.
25
(1) Upper level mark
(2) Lower level mark
(3) Oil filler cap/dipstick