Maintenance - Scotsman CME1056R Indicaciones Para El Uso

The Bin Full indicator light will go on and off as ice falls
from the evaporators.
8. Machines are shipped from the factory with the purge
level set to accommodate average water conditions. To
achieve optimal machine performance, set the purge
level to the minimum setting.
Note: While the amount of water purge is adjustable,
only those installations with a water supply known to be
excellent (very low TDS) should adjust to the minimum
setting. See the next page for purge adjustment
procedures.
9. After about 6 minutes (first cycle after any restart) the
machine will return to a freeze cycle.
Note: After the first harvest, the controller will adjust the
harvest time as needed to release all ice.
10. The reservoir refills at the beginning of Freeze.
11. Fill out the Customer Evaluation and Warranty
Registration. Send it to Scotsman.
12. Return all panels to their normal positions.
13. Inform the user of the location and telephone number
of the local service company. Inform the user of the
required maintenance of the machine.
Operational Notes:
1. The machine will only shut off on Bin Full at the end
of the Harvest Cycle after the bin fills. That last harvest
cycle will be about 6 minutes long.
2. After switching off on Bin Full, if ice is removed from
the bin, the machine will not restart until it has been off
for 4 minutes. If the Freeze button is pushed, the
machine will restart immediately.
3. If the bin controls sense a bin full signal before any
water is used (float stem up), the machine will shut off
on bin full.
4. When shutting off, the compressor will run for 30
seconds (everything else will be off) and then switch off.
How To Operate The Controller
The Controller is a microprocessor based device that
receives input from several sources and switches various
components on and off.
Its manual control is through the use of the Push Button
Control Switches
1. Freeze Button. Pushing and releasing this button starts or
restarts the machine. The System Controller remembers what
cycle it was last in and returns to that cycle.
2. Harvest Button: Pushing and releasing this button will cause
the machine to go directly to a Harvest Cycle. Can be done from
Freeze or Off. The machine will switch Off at the end of the
Harvest cycle.
3. Clean Button: Pushing and releasing this button will cause
the machine to empty the reservoir, refill and leave only the
water pump on for circulation of ice machine cleaner. After the
ice machine cleaner has circulated for about 10 minutes a
second push of this button will switch on the rinsing system to
flush out the dissolved scale and ice machine cleaner.
4. Off Button: Pushing and releasing this button will switch the
machine OFF at the end of the next cycle. If the button is
pushed and HELD for more than 3 seconds, the unit will switch
off immediately.
To Reset Machine (machine off, error light on): First push and
release the Off button, then push and release the Freeze button.
Sanitizing and Cleaning
The following is a list of recommended maintenance that will
keep the machine running with a minimum of problems.
Cleaning and Sanitizing should be scheduled to occur at least
twice per year of use.
Ice Making System
Warning: Before proceeding with any cleaning or maintenance
operation, make certain that the electrical power has been
disconnected.
Monthly:
Clean the ice storage bin liner by wiping it with a clean cloth
and a mild detergent diluted in lukewarm water.
Rinse it and then thoroughly disinfect its surfaces by wiping
them with a liquid algaecide.
Clean the outside of the cabinet with a mild detergent solution.
Water System
The water system is critical to the proper operation of the ice
machine. Have it cleaned by the authorized service agent at least
twice per year.
13