Tabla De Contenido; Introduction; Warranty; Installation - Scotsman CME1056R Indicaciones Para El Uso

User Manual for
Modular Ice Cube
Machine
Models CME1056R
and CME1356R and
CME1656R
Table of Contents
Introduction . . . . . . . . . . . . . . . . . page 3
Warranty . . . . . . . . . . . . . . . . . . page 3
Installation . . . . . . . . . . . . . . . . . page 3
Location and Assembly . . . . . . . . . . . page 4
Plumbing . . . . . . . . . . . . . . . . . . page 9
Electrical . . . . . . . . . . . . . . . . . . page 10
Final Check List. . . . . . . . . . . . . . . page 10
Initial Start Up . . . . . . . . . . . . . . . page 12
Maintenance. . . . . . . . . . . . . . . . . page 13
Failure Analysis. . . . . . . . . . . . . . . page14

INTRODUCTION

This product manual contains the information needed for
the setup, installation, initial start up, sanitation and
maintenance of this ice machine. Keep it for future
reference.
There are 3 models covered in this manual:
CME1056R, with 3 evaporators
CME1356R, with 5 evaporators
CME1656R, with 6 evaporators
Be certain that the information applies to the model in
question. If no model is listed, the information applies to
all models.

WARRANTY

The warranty conditions are those supplied by the official
distributor for your area. In case of parts, only genuine service
parts may be used.
Installation Limitations
These ice machines are designed to be installed indoors, in a
controlled environment. They can operate satisfactorily under a
wide variety of conditions. Do NOT operate the machine in
temperatures it has not been designed for. Do NOT operate the
machine above or below the voltage limits for the particular
model. Do NOT operate the machine with too little or too much
water pressure.
Operational Limits
Air Temperature
Water Temperature
Water Pressure
Voltage (50 Hz model)
Inlet water flow required is 2.7 GPM (10 liters per minute)
The CME1356 and CME1656 models will fit a standard, 1.2 m
wide Scotsman Ice Storage Bin such as the BH900.
The CME1056R will fit a standard 30 inch wide Scotsman bin.
Note: Slope front bins must have an internal baffle. Scotsman's
BH900 has the required baffle.
A stacking kit, for like models, is KSCME6-LG
Scotsman reserves the right to make design changes and/or
improvements at any time. Specifications and designs are
subject to change without notice.
Pre-Installation
Check the nameplate for electrical requirements. The nameplate
is located on the back of the ice machine. While the model and
serial number are on the nameplate, a serial number plate is
located at the front of the machine, near the purge valve.
3
Minimum Maximum
o o
10 C 40 C
o o
4 C 40 C
1 bar 5 bar
207 253