Acknowledge Events Or Faults; Setting A Ferry/Train Crossing; Digital Tachograph Not Required (Out); Speed Monitoring ( >> Warning) - intellic EFAS Manual De Instrucciones

5.6

Acknowledge Events or Faults

When certain events or faults occur, EFAS displays a warning (see section 11) in that a signal tone
sound for 30 seconds and a warning lamp flashes. The warnings will be displayed until they are con-
firmed by OK. Use control keys
5.7

Setting a Ferry/Train Crossing

When using a ferry or a train with your vehicle, you have to set the condition "Ferry/Train Crossing".
Select OK
1.
Inputs
Press OK.
2.
The condition "Ferry/Train Crossing" is deactivated automatically when your vehicle starts moving again..
5.8

Digital Tachograph not Required (OUT)

For trips which are excluded from the provisions of EC Regulation or the driving staff regulations, you
may activate the condition „Digital tachograph not required" (OUT).
Select OK
1.
Inputs
Press OK.
2.
In order to switch-off the condition „Digital tachograph not required" (OUT)
Select OK
1.
Inputs
Press OK.
2.
5.9 Speed Monitoring ( >> Warning)
Besides the legally prescribed monitoring of the maximum permissible speed of the vehicle, EFAS allows
for surveillance of an individually programmable speed limit. Once the vehicle has been parameterized
accordingly, this speed limit can be adjusted in two different ways.
Setting via menu (when the vehicle is stationary):
Select OK
1.
Setting
2. Use control keys
your individual warning.
3. Select "OFF" to switch-off speed warnings
Setting when the vehicle is moving:
1. Use control keys to switch to a display where speed is shown.
Press OK for the speed to be monitored.
2.
In order to switch-off speed monitoring when the vehicle is moving, press ESC.
5.10

Remote Data Transmission (Device option)

®
When a RDD device (Remote Data Download) is connected to EFAS, the following functions are avail-
able.
5.10.1 Initiate Transfer of Driver Card Data (Over the Air)
The initiation of the transfer of driver card data via RDD
the ignition is switched on.
With the driver card inserted, select OK
11
or to display additional information about the warning.
Begin.
OUT Begin.
OUT End.
>> Warning
or to adjust the desired speed which shall trigger
Remote Transfer
®
is only possible if the vehicle is stationary and
Send Card Data. If two driver