Grillo GF2 Uso Y Mantenimiento página 23

STEEL WHEELS WITH ANTIDRIFT
These wheels are particularly useful when mowing on hillsides.
The cross-bars on the wheel circumference and the external ring penetrate into the ground, ensuring good
anchorage of the machine to the soil and allowing work on 60% slopes (fig.14).
CUTTER BAR SIDE PROTECTION
It is used to prevent the cutter bar bumping against walls or damaging trees.
It is fitted at the end of the cutter bar (fig.15).
MOWING SULKY
This attachment allows the operator to mow flat ground from a comfortable sitting position. The anchor
bracket is applied under the gearbox, between the 2 drive wheels.
TILLER
The tiller is used for breaking up the upper layer of the ground to raise permeability and at the same time
free it from weeds. Tilling can be done in first gear if the ground is hard or in second if the ground is loose
or sandy. Tilling depth can be adjusted by raising or lowering the middle blade located under the tiller body.
To increase the depth, the blade must be moved upwards (fig. 16/A). It is a good rule to begin work with
the blade in the lowest position and then raise it if greater depth is wanted.
N.B. - In hard ground, if the machine tends to jump forward, lower the blade as far as possible,
locking if in the third hole (fig. 16). The standard tiller is 58 cm wide and can be adjusted to 50 - 36.
CAUTION! INSTRUCTIONS FOR MECHANICS
When assembly this machine, remember that extraction of the thrust bearing ring on the engine end of
the work gear requires a special tool available to order.
TRAILER
The trailer is mounted on the tool flanging. It is equipped with a dumper and reversible wheels to make
steering easier (Fig. 17).
TILTING BLADE cm. 80
This highly resistant device is ideal for removing snow and levelling mounds of soil or gravel. May be tilted
to the right and left (Fig. 18).
23