Orientation Of The Appliance - Hupfer SPA/EB-1 Manual De Instrucciones

Introduction

Orientation of the Appliance

Term
Porcelain Standard
Protection class
Qualified person,
qualified staff
Schuko®
Specialist
suitable for washing devices
Verify, test
VESKA standard
1.4 Orientation of the Appliance
Front
The "front" refers to the side where the controls are arranged. The operating staff stays on this side to move
the mobile bain marie.
Rear
The "rear" refers to the opposite side to the front.
Right-side
The "right" refers to the right hand side when viewed from the front side (front).
Left-side
The "left" refers to the left hand side when viewed from the front side (front).
4330002_A2
Definition
Porcelain Standard is a measurement system for porcelain plates devised by
®
HUPFER .
The basic size of Porcelain Standard (PN) 1/1 is 8.7 x 6.3'' (220x160 mm) (1/2 PN
conforms to 4.3x6.3'' (110x160 mm), 1/4 PN conforms to 6.3x3.1'' (160x80 mm)). The
fitting lids have the following dimensions: 1/1 PN 9x6.6'' (228x168mm), 1/2 PN
4.4x6.3'' (111x161mm), 1/4 PN 4.4x3.2'' (111x81mm).
0
¯
I
II
III
Qualified staff are persons who due to their professional training, experience, instruc-
tion and their knowledge of relevant standards, guidelines, accident prevention regula-
tions and operating conditions have been authorised by a person responsible for
system safety to carry out required activities and can recognise and prevent any
potential dangers (definition of specialists according to IEC 364).
The abbreviation of the German term "Protective contact" indicates a system of do-
mestic plugs and sockets equipped with protective earthed contacts used in most of
Europe.
A specialist is a person who can evaluate work assigned and can individually recog-
nise any possible dangers due to professional training, specialist knowledge and
experience as well as knowledge of the respective guidelines.
The appliance is suitable for cleaning in an automated washing device without re-
strictions. Following agreement with the manufacturer the washing device must
achieve a hygienic, constant cleaning and drying result, which is to be approved by a
third party (client).
The exterior and interior housing are manufactured to a standard guaranteeing her-
metic sealing. It is not possible for pressurised water to ingress into hollow spaces in
the appliance. Installed electrical components and electrical wiring are protected by
appropriate sealing against any form of penetration by water. Protection class IPX6
(powerful pressurised water) to DIN EN 60529 (VDE 0470) is guaranteed. No water
remains or is carried over following the drying process.
Compare with certain values such as weight, torque, content or temperature.
Trays as per the VESKA standard are items used for distributing food in hospitals,
principally in Switzerland; they measure 20.9x14.8" (530x375 mm)
SPA/EB-1 | SPA/EB-2 | SPA/EB-2F | SPA/EB-2LS | SPA/EB-3 | SPA/EB-3F | SPA/EB-3LS | SPA/EB-4
Protective measure with protective earth conductor
Protective measure with protective insulation
Protective measure with protective low voltage
Chapter 1
Page 7
Mobile Bain Maries