Section 5
Page 24
NOTE
§
Load the banquet trolley quickly. Ensure that the door does not remain open unnecessarily to keep
heat loss as low as possible during the loading.
§
Leave the appliance connected to the mains after it has been loaded until the operating temperature
is reached again. The control lamp on the switch panel switches off when the temperature is reached.
Step 4: Moving
§
Switch off the banquet trolley at the on/off rotary switch with thermostat by turning the rotary switch to
the left.
§
Pull out the mains plug and insert it into the plug park provided on the banquet trolley or reel it up on
the thermal module.
§
Release the total brakes.
§
Push or pull the banquet trolley to the destination place.
§
Lock with the total brakes and make sure that they are engaged and that the banquet trolley cannot
be moved.
§
Reconnect the banquet trolley to the mains.
Step 5: Unloading
WARNING
§
Select the temperature range using the on/off rotary switch with thermostat to switch the heating back
on by turning the rotary switch to the right.
§
We recommend a temperature of approx. 203°F (95 °C). Set to the maximum level about 10 minutes
prior to serving meal and keep this setting until the end of serving.
§
Proceed with serving as quickly as possible.
§
Whenever the serving procedure is interrupted, close the door immediately!
5.2.2
Neutral Banquet Trolley
Step 1: Loading
§
Put Gastronorm containers or portioned meals on grids into the banquet trolley.
Step 2: Moving
§
Release the total brakes.
§
Push or pull the banquet trolley to the destination place.
§
Lock with the total brakes and make sure that they are engaged and that the banquet trolley cannot
be moved.
Step 3: Unloading
§
Proceed with serving. If the serving procedure is interrupted, make sure to close the door.
Banquet trolley heated | neutral
BKW1/14 L-GN | BKW1/20 L-GN | BKW1/36 B-GN | BKW1/14 L-GN+5PK | BKW1/28 B-GN+10PK | BKW1/23 L-GN
Inserting the Gastronorm containers
Leave a space of at least 1.77'' (45 mm) between the bottommost Gastronorm
container and the upper edge of the thermal module to avoid heat accumula-
tion.
Danger of escaping steam
Hot steam can escape when opening the door. Risk of burning.
Please stay at a safe distance and wait until the steam has volatilised.
Operation
Operation
91101983_A4