Wall Mount Bracket / Motor Assembly; Motor / Rear Grille And Blade Assembly; Front Grille Assembly - Kichler POLA Manual De Instrucciones

Wall Mount Bracket / Motor Assembly

1. Remove the 2 bolts (11), washers (10) and nuts (12) from
the wall mount / pipe (7).
2. Align the holes on the pipe with the holes in the motor
flange on the motor assembly.
3. Insert the bolts (11) and replace the washers and nuts
removed in step 1.
4. Adjust the tilt to the desired positionand tighten the pivot
knob (8) to set the angle.
5. Tighten the position bolt and nut.
CAUTION: Be sure to secure the knob.

Motor / Rear Grille and Blade Assembly

1. Remove the 4 nuts, spring washers and flat washers
(15,16,17) from the bolts around the motor shaft.
2. Carefully slide the rear grille (14) over the bolts.
3. Secure with the flat washers, spring washers, and nuts
removed in Step 1.
4. Carefully slide the blade assembly (18) over the shaft and
align the inner hex head driver (20) provided with the slot
on the shaft of the motor.
5. Tighten the blade assembly (18) with the screws using a
philips-head screwdriver (not provided).
CAUTION: Do not alter the angle of the blades.

Front Grille Assembly

1. Hang the front grille (19) on top rib of rear grille (14) by
utilizing the hook.
2. Put the decorative ring (17) into the front grille (19), then
insert the bolts (22) and tighten the nut (20) to following
interface.
3. Snap the front grille into the rear grille to secure.
4. Cover with decorative screw cover (21).
Install the mounting bracket decorative cover (1) to the
mounting bracket last.
7
18" POLA WALL FAN |