SUHNER UBC 10-R Documentación Técnica página 5

chine at operating temperature the temperature-
dependent overload protection reacts correspon-
dingly earlier.
Undervoltage / restarting protection
On short time power failure (pulled power plug,
instable power supply etc.) the machine will stop.
When the power voltage is restored, the machine
has to be turned OFF and then back ON again.
Once this has been done the machine is again
ready for operation.
Speed selection
Select required speed with variable speed selector
5 for correct m/s or surface feet.
Speed selector Speed
Position rpm
1 4'000
2 5'000
3 6'000
4 7'000
5 8'500
6 10'000
Recommended working position
The smaller the belt, the easier it can slip from the
contact wheel.
To avoid this, we recommend
- to dose the working pressure with the contact
wheel 14.
- to operate belt grinder on the pulling side 18.
Change of belts and contact arms
• Before changing, disconnect the tool from
power source.
• Align contact arm 15 with Nut 8 or 9.
• Mount belt 16 on contact wheel, press contact
arm firmly against flat object, observe direc-
tion of arrow for correct belt travel and rest on
drive wheel 7.
• Pull belt through by hand., adjust tracking with
screw 8 or 9 to stop from wandering off from
contact wheel 14. Switch on grinder, selecting
Pos 1 on variable speed selector. Make fine
adjustments, then set with Lock-in srew 10.
Additional Adaptation possibilities
Change of belt tracking axle towards motor-
spindle
Loosen with Hex wrench 4 Allen screw 3. Adjust
and retighten.
Adjusting tension
Thin and small belts need less tension. this can
be adjusted by removing the attachment - (loosen
screw 3 with Allen wrench 4 ) and set tension with
set screw 11 and wrench 4 to optimize grinding.
Adjust torsion play on the longitudinal axis of
the contact arm
With srew 12 and counter lock nut 13.
Maintenance
• Store tool in a clean, dry place.
• Disconnect tool when not in use and before
• The ventilator openings for cool air must be
Belt speed
m/s
• Replace grease in grinder head every other
6,5
8,0
9,5
• Damaged plugs and cords must be replaced
11,0
13,0
• Repairs must only be done by a qualified/
15,5
• Warranty claims can only be considered, if
Accessories
All accessories can be found in the
sive Power Tool catalog.
Subject to change!
servicing.
kept free and clean, use air gun to blow out
dirt.
time, when carbon brushes are replaced. Use
the authorized service center nearest
you .
immediately.
licensed electrician, otherwise it could be ha-
zardous to the operator.
tool is returned complete.
Abra-
5