For A Usb Connection; With Windows® 98 - Brother P-Touch 9200DX Guía De Referencia Rápida

5 Check that the baud rate will be changed as desired,
and then click the Next button.
To change the settings, click the Back button, and
make the necessary changes.
6 When the dialog box appears, showing that the baud
rate has been set as specified, click the Finish button.
7 If installation of the printer driver is not complete,
finish installing it.

• For a USB connection:

With Plug and Play, new devices connected to the system
are detected, and their drivers are automatically installed. If
the PT-9200DX is connected through the USB port, its driver
will be installed with Plug and Play. Be sure to read the
installation instructions described below before installing the
file supplied on the CD-ROM.
Take extra care when installing the printer driver on a com-
puter running Windows® 2000.
With Windows® 98:
The software and printer driver installation should be per-
formed in the following order:
(1) P-touch Editor Version 3.1
(2) USB printer driver
1 With a USB installation, the P-touch should not be
connected to the computer before installing P-touch
Editor Version 3.1.
. Make sure that the P-touch is not connected to the
computer, otherwise P-touch Editor Version 3.1 may
not be installed correctly.
2 Insert the P-touch Editor CD-ROM into the computer's
CD-ROM drive. A dialog box that allows you to select
what to install automatically appears.
12
If the dialog box does not automatically appear,
double-click "My Computer" on the desktop, double-
click the icon for the CD-ROM drive containing the
CD-ROM, and then double-click "Ptsetup.exe" to
display the dialog box.
3 Click the top button (P-touch Editor).
(1) P-touch Editor Version 3.1 installation
4 Install P-touch Editor Version 3.1 according to the
procedure described in P-touch Editor Version 3.1
Installation on pages 20 through 21.
5 After installation of P-touch Editor Version 3.1 is
finished, install the USB printer driver as described
below.
(2) USB printer driver installation
6 In the Port Selection dialog box that appears, select
"USB", and then click the Next button.
7 The USB message dialog box appears. (Do not click
the Finish button.)
8 Connect the P-touch to the computer using the
enclosed USB interface cable, and then turn on the P-
touch.
9 After the Found New Hardware dialog appears, click
the Next button in the first Add New Hardware
Wizard dialog box that appears.