Connecting The Interface And Power Supply Cables - Brother P-Touch 9200DX Guía De Referencia Rápida

Connecting the interface and power supply cables

Connect the PT-9200DX to the computer according to the instructions below.
When connecting to the serial port:
Serial
1 Make sure that both the PT-9200DX and the computer are turned off.
2 Connect one end of the enclosed serial interface cable to the serial connector (IOIOI) of the PT-9200DX and the other
end of the cable to the serial port of the computer. For a Macintosh® connection, connect the PT-9200DX to either the
modem or the printer port (preferably the modem port).
. The serial (RS-232C) ports of some computers are shaped so that the serial interface cable cannot be connected.
If this is the case, use a commercially available adapter.
When connecting to the USB port:
. Read the installation procedure on pages 12 through 19, and then follow the instructions to install the printer.
1 Connect one end of the enclosed USB interface cable to the USB connector (
end of the cable to the USB port of the computer.
. Do not connect the PT-9200DX to the computer using both the serial and the USB interface cables, otherwise
the PT-9200DX may be damaged.
. When making a USB connection through a hub, a proper connection may not be possible due to the type of hub
used. If printing is not possible with a hub connection, try connecting the PT-9200DX directly to the computer
using the USB interface cable.
2 Insert the power cord into the PT-9200DX.
3 Insert the power cord plug into an AC outlet equipped with a grounding terminal. Some locations may require the use
of an adapter provided with a grounding wire. Connect this wire to the ground terminal.
USB
) of the PT-9200DX and the other
3