Brother P-Touch 9200DX Guía De Referencia Rápida página 21

V The Brother PTUSB Printing Properties dialog box
appears. (This is the same as the previous USB Printing
Support Properties dialog box; however, since the
class driver has been replaced, the dialog box name
has changed.) Close this dialog box and the Device
Manager dialog box, and then click the OK button in
the System Properties dialog box.
W After installation of the class driver is finished, install
the port monitor as described below.
(4) Port monitor installation
X Click the Start button in the taskbar, select "Settings",
click "Control Panel", and then double-click "Print-
ers". Right-click "Brother PT-9200DX", and then
remove the check mark beside "Use Printer Offline".
18
Y Right-click "Brother PT-9200DX" again, and then
select the "Properties" command.
Z In the Brother PT-9200DX Properties dialog box that
appears, click the "Ports" tab, and then click the Add
Port button.
[ In the Printer Ports dialog box that appears, click the
New Port Type button.
\ In the Installing Print Monitor dialog box that appears,
click the Browse button, specify the file
"d:\ptouch\driver\pt9200dx\win2000\usb\port\monitor.inf"
(where "d:" is the name of the drive containing the P-
touch Editor CD-ROM), click the Open button, and
then click the OK button.