P-Touch Editor Version 3.1 Installation (For Macintosh®); Installing P-Touch Editor Version 3.1 - Brother P-Touch 9200DX Guía De Referencia Rápida

P-touch Editor Version 3.1 Installation
(for Macintosh®)
Follow the procedure below to install the P-touch Editor
software on the Mac.
Check that your system configuration meets the following
requirements.
Computer: Macintosh or Power Macintosh
Operating system:
Serial interface:
®
Macintosh equipped with a PowerPC processor
and a serial port (modem or printer), and running
Mac OS 8.1 or later
USB interface:
Macintosh ® equipped with a USB port and running
Mac OS 8.5.1 or later
* For previous Mac OS versions, refer to the Apple
Web site for information about USB.
* The application is supplied on a CD-ROM;
therefore, the computer should be equipped with
a CD-ROM drive.
Hard disk free space: At least 20 MB
. A few hundred megabytes of additional free space
may be needed when printing long labels or large
amounts of data.
Port: Serial or USB
Available memory free space: Minimum 24 MB
CD-ROM drive
With the enclosed CD-ROM, the following can be installed:
• P-touch Editor Version 3.1
• PT-9200DX printer driver

• Installing P-touch Editor Version 3.1

1 Connect the PT-9200DX to the Macintosh® using the
enclosed interface cable. Be sure to leave the PT-
9200DX turned off.
2 Turn on the Macintosh.
3 Insert the P-touch Editor CD-ROM into the computer's
CD-ROM drive.
4 Double-click the P-touch Editor 3.1 Installer icon in
the folder that appears.
22
5 After the installer starts up, select the installation
method.
Clicking the Install button immediately starts installing
the most basic options. (Some clip art illustrations are
not installed.)
About 20 MB of available hard-disk space is needed to
begin installation. In order to install all options, about
120 MB of available hard-disk space is needed. If
enough hard-disk space is available, click the Install
button.
Clicking the Custom Install button displays a dialog box
that allows you to select which options to install. Only
the options with a check mark beside them are
installed.
Select the options that you wish to install, and then
click the Install button.
Dialog box that appears if the Custom Install button is
clicked
6 Installation begins.
7 When the installation is finished and the following
dialog box appears, click the Quit button.