5.1 Personal Protective Equipment
When working on and with the collet chuck CAPTIS-M, personal protective
equipment must be worn. The owner is responsible for providing personal
protective equipment.
■
Personal protective equipment must be in perfect condition when
carrying out work. Defective safety equipment is to be replaced
immediately.
■
Observe information on personal protective equipment posted in the
working area.
Wear ear protection
5.2 Mounting with Flange or Base Plate
5.2.1 Flange Pursuant to DIN-ISO702-1 / DIN-ISO 702-4
1.
Put machine into set-up mode.
2.
Clean the fitting surfaces of the machine spindle.
3.
Check the fitting surfaces of the machine spindle for radial and axial
run-out.
122017 / 1.0
Flange pursuant to DIN-ISO702-1 / DIN-ISO 702-4 see
Chapter 5.4 Optional Accessory, page 76.
Wear foot protection
Wear hand protection
Assembly
68