Fixing And Replacing Screws - Rohm CAPTIS-M Traducción De Las Instrucciones De Servicio Originales

Complete cleaning
Approx. every 500 operating hours depending on conditions of use.
1. Completely disassemble the collet chuck CAPTIS-M.
2. Free all individual parts of oil, grease and dirt with a non-aggressive,
commercially available detergent and a cloth.
3. Grease all individual parts and re-assemble. On assembly, observe
Chapter 8.4 Fixing and Replacing Screws, page 91.
Recommended grease F80:
0.1 kg
0.25 kg
0.5 kg

8.4 Fixing and Replacing Screws

If screws are replaced or undone, incorrect replacement or attachment may
lead to dangers for persons and objects. For this reason, for all fixing
screws, the tightening torque recommended by the manufacturer of the
screw must be used in accordance with the screw quality.
Tightening torques in Nm
Quality M5
8.8 5.5
10.9 8.1
12.9 9.5
When using original screws, in the event of doubt, the screw quality 12.9 is
to be used. in the case of mounting screws for clamping inserts, top jaws,
rigid stops, cylinder covers and comparable elements, quality 12.9 is always
to be used.
122017 / 1.0
ID no. 630869
ID no. 304345
ID no. 308555
M6 M8 M10
9.5 23 46
13 33 65
16 39 78
The table values do not apply to tightening torques expressly
specified elsewhere!
1 kg
5 kg
25 kg
M12 M14 M16
80 130 190
110 180 270
140 220 330
Maintenance
ID no. 028975
ID no. 318310
ID no. 658047
M18 M20 M22
270 380 510
380 530 720
450 640 860
M24
670
960
1,120
91