Operation Instruction - Kichler JACE Manual De Instrucciones

OPERATION INSTRUCTION

ACTIVATING THE LEARNING PROCESS(Fig.21)
NOTE：The control system for this fan is equipped with a learning frequency function which
has 56K code combinations to prevent potential interference from other remote units.
The frequency on your receiver and wall transmitter units have been preset at the factory.
No frequency change is necessary. If the fan is non-functional or if you desire to install another
fan within the same home or area with a separate frequency code, please see below "leaning
process "section of this instruction manual to code-paring the receiver and wall transmitter.
1.Use a small flat screw driver and gently pry the faceplate apart from the top of wall transmitter.(Fig.21)
2. After installation is complete, AC power is turned on and
seconds,press and hold the LEARN button for 3 seconds. Fan will turn on at medium speed and light
(if installed) will turn on. This confirms that the SMART SYNC setting is active and ok. (FIG. 21)
3. If user cannot finish the setting within the 30 seconds time frame, the main power must be turned o
and re-started again. This will reset the unit. Repeat step 2 until the LEARNING feature is activated as
indicated.
LIGHT FUNCTION SELECT SWITCH(Fig.21)
1. D means " dimmer "
O means " only on/o ,no dimmer"
The light of this fan can be dimmer, so it has been set to "D" at factory side. If you want the light to be only
on/o ,please kindly switch it to "O"
WALL TRANSMITTER OPERATION (Fig. 22)
ON/OFF: Active the wall transmitter or Lock the wall transmitter.
FAN OFF :Turn o the ceiling fan.
HI : Turn on the fan at high speed.
MED : Turn on the fan at medium speed.
LOW: Turn on the fan at low speed.
LIGHT: Turns the light ON or OFF. Press and hold the button to set the desired brightness.
REV: Press this button for forward/reverse airflow of ceiling fan.
18 | KICHLER.COM
SWITCH is at ON position within 30
LEARN
Fig. 21
light function selection switch
Fig. 22
faceplate