Kichler JACE Manual De Instrucciones página 8

HANGING THE FAN
Step 5. Remove the hanger ball from the downrod assembly by
loosening the set screw, unscrewing and removing the cross
Step 6. Loosen the two set screws and remove the hitch pin and
retaining clip from the coupling on top of the motor assembly. (Fig. 8)
Step 7. Carefully feed the electrical lead wires from the fan up through
the downrod. Thread the downrod into the coupling until the Hitch pin
holes are aligned.
Next, replace the hitch pin and retaining clip. Tighten both set screws.
(Fig. 8)
8 | KICHLER.COM
(continued)
Cross pin
Hanger
ball
Set screw
Fig. 7
Supply wires
Downrod
Set screws
Retaining clip
Fig. 8
Downrod
Set screws
Hitch pin