Publicidad
Idiomas disponibles
Idiomas disponibles
52. Remove the 12V ignition power outlet from the I/P
lower bin area as follows:
a. Look inside and note position of the retaining bosses
(2).
b. Insert Power Outlet Remover 10246 (1), or equivalent
into the retaining bosses (2) of the power outlet.
c. Pull out the base through the mounting ring by gently
rocking the tool.
d. Disconnect the harness from the power outlet and set
the outlet aside.
e. Pull the 12V ignition power outlet wiring harness con
nector through the opening in the back of the center
stack area for splicing.
NOTE: The I/P end of the backup camera harness (2)
has the two wires without terminal ends for splicing
to the 12V ignition power outlet connector (1).
NOTE: Ensure when routing the wire harness not to
damage the wire terminals.
53. Feed the backup camera wiring harness (2) from the
LH side of the I/P near the park brake pedal over the
brake pedal sled and through the lower I/P and into the
center I/P stack area for connecting to the 12V igni
tion power outlet wiring harness connector (2) and the
TGM. Secure to the vehicle harness with tie straps.
54. Remove enough of the insulating tape from the wires
of the 12V ignition power outlet wiring harness con
nector (1) to splice into the two wires.
55. Prepare to crimp/splice the backup camera power wire
(PK/OR) to the (DB/PK) of the 12V ignition power out
let wiring harness connector as follows:
a. Cut the 12V ignition power outlet DB/PK wire.
b. Remove 13 mm (0.5 in.) of insulation from each
wire that needs to be spliced.
c. Place a piece of adhesive lined heat shrink tubing
(2) on one side of the wire. Make sure the tubing
will be long enough to cover and seal the entire
repair area.
d. Place the strands of wire overlapping each other
inside of the splice clip (1).
Feb 02, 2011
www.mopar.com
11
K6861161
Publicidad
