Mopar Journey Manual Del Usuario página 15

65. Carefully connect the 40 way connector (1) of the
switch­bank assembly.
66. Position the switch­bank in the I/P and press evenly
the engage the two lower clips (3).
67. Install, and tighten the two screws (2) that secure the
switch­bank (1) to the I/P (4).
68. Install the I/P trim to the left and right of the switch
bank.
NOTE: Routing under the I/P should be above the
brake pedal sled and secured to eliminate possible
interference with all pedal movement.
under the kick panel should be secured to eliminate
possible interference with all pedal movement.
69. Route the backup camera wire harness from under the
LH side of the I/P (above the brake pedal sled) behind
the LF kick panel and secure to the vehicle harness
with tie straps.
70. Route the backup camera wire harness (4) with the
vehicle wiring harness (2) under the edge of the carpet
(1) below the LF door scuff plate and below the B­pillar
lower trim (3). Attach to the vehicle wiring harness (2)
with tie straps where necessary.
Feb 02, 2011
www.mopar.com
Routing
15
K6861161