Mopar Journey Manual Del Usuario página 14

14
NOTE: There may already be a 22 pin connector con­
nected to the TGM. Use that one and discard the one
supplied in the kit.
61. Back out the connector wire locking tab from the TGM
harness connector 3.
62. Insert the camera harness wires into TGM harness
connector 3 as follows:
a. Signal wire (GY/LB) ­ cavity 15
b. Return wire (GY/OR) ­ cavity 16
c. Shield wire (Bare) ­ cavity 17
63. Connect the antenna(s) (1), RF HUB and UCI cables
(4), video cable (3) and wiring connectors (2) to the
TGM.
NOTE: Make sure the 40 way connector (1) of the
switch­bank assembly is positioned above the
TGM for access when connecting the switch­bank
assembly.
64. Position the TGM (2) and install the retaining screws
(1) to the Telematics Gateway Module (TGM) (2).
Feb 02, 2011
www.mopar.com
K6861161