Descargar Imprimir esta página

Mopar Journey Manual Del Usuario página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

58. Center the heat shrink tubing (2) over the solder joint
and heat using a heat gun. Heat the joint until the tub­
ing is tightly sealed and sealant (1) comes out of both
ends of the tubing.
59. Crimp/splice the backup camera ground wire (BK) to
the ground (BK) of the 12V ignition power outlet wiring
harness connector as above.
60. Install the 12V ignition power outlet as follows:
a. Feed the 12V ignition power outlet wiring harness con­
nector (1) through the opening in the back of the center
stack area and connect to the receptacle (2).
b. Align the splines on the outside of the power outlet re­
ceptacle base connector receptacle with the grooves on
the inside of the mount.
c. Install the power outlet into the panel by pressing firmly
on the power outlet receptacle base until the retaining
bosses of the mount are fully engaged in their recepta­
cles.
Feb 02, 2011
www.mopar.com
13
K6861161

Publicidad

loading

Productos relacionados para Mopar Journey