Ventilation; Locking System; Storing The Helmet - SCHUBERTH C3 PRO Manual Del Propietário

H. MAINTENANCE AND CArE

5. VENTILATION

Ventilation cowl
When necessary, the head ventilation system's air inlet cowl can
be removed to clean the ventilation mechanism.
1. To do this, first remove the control
unit by simply lifting it out of the
ventilation cowl.
2. Then slide the flat end of the
control unit under the edge behind
the ventilation cowl and remove
the latter by levering it upwards.
3. On completion of the cleaning,
fix the ventilation cowl back in
place by hooking it into the front
of the ventilation mechanism and
pressing it into the helmet shell
until you hear an audible click.
4. When this has been done, insert
the control unit through the
ventilation cowl and into the
ventilation mechanism.
56

6. LOCkING SYSTEM

Ratchet fastener
The metal components of the locking system do not require
maintenance.

7. STORING THE HELMET

When not in use, keep the helmet in the supplied helmet bag in a
dry, safe place. Always store the helmet so that there is no risk of
it falling onto the floor. Damage caused this way is not covered by
the guarantee.
Note:
Store the helmet out of reach of children and animals.
Note:
The active anti-fog coating also absorbs other chemical
substances such as solvents and can be damaged by them.
Therefore, avoid storing the faceshield and sun visor in the
vicinity of aggressive substances such as motor fuels.
57