SCHUBERTH C3 PRO Manual Del Propietário página 5

C. rEAD FIrST
Warning:
Never modify your helmet!
It is very dangerous to drill holes or to cut the shell and/
or the shock absorbing liner. Modification can seriously
weaken the helmet. Modifying the retention system
weakens it, increasing the likelihood of snapping during
impact. Removing parts such as the mouth guard or rubber
face molding can expose edges that may injure you in
an accident. Always use approved SCHUBERTH parts when
replacing shields, screws, or any other parts. A weakened
helmet will not provide head protection.
Warning:
Don't mistreat your helmet!
Never ride with the helmet hanging from the helmet holder,
and do not hang the helmet from angled supports such as
a mirror. Do not sit on or throw your helmet. You should
not expose the liner of your helmet to strong sunlight and
excessive heat such as near heaters or where temperatures
exceed 50 °C (122 °F). Avoid spraying insect repellent chemicals
(such as "naphthalene") near the helmet. Mistreating your
helmet will damage the shell and impact absorbing liner,
reducing the helmet's ability to protect you in an accident.
Warning:
Clean your helmet carefully!
Only use lukewarm tap water, never benzene, gasoline,
glass cleaner or other solvents. Your helmet can be seriously
damaged by these substances without visible damage. A
helmet damaged or weakened by a cleaning agent may not
provide head protection in an accident, resulting in serious
personal injury or death.
8
Warning:
Always check your helmet before every ride!
1. Check the Face Shield and sun visor.
2. Check the correct function of the shield and visor mechanics.
3. Check for cracks in the helmet. Strong acid (e.g. battery acid)
can damage the shield bases. If you find cracks or damage,
stop using the helmet immediately.
4. Check helmet for deterioration. If you find deterioration in
any part of a component, either replace that component
or get a new helmet. If these parts come loose and/or fall
off while you are riding, your vision may be blocked, which
could cause an accident resulting in serious personal injury
or death.
5. Check the security of the retention system (see section G. 3.).
For checking instructions and procedure see also section F.
(before every journey) of this manual.
Warning:
Maintain your helmet shields (shield and sun visor)
in good condition!
If your shields become too scratched or uncleanable, replace
them with new ones. Impaired visibility may cause accidents.
Clean your shields only with mild soap diluted in tap water.
Rinse well with clean tap water, and dry with a soft cloth.
Never use benzene, gasoline, glass cleaner or any other solvents.
Do not attach stickers or adhesive tape to the shields, as this
will weaken the hard coating, damaging the shields. Do not
drive with a dim or blurred shield. Impaired vision can cause
an accident resulting in serious personal injury or death.
Warning:
Never use the tinted sun visor at night, in poor
visibility conditions or in tunnels!
The tinted visor reduces light transmission and should never
be used in situations where vision is impaired (i.e. at night,
in poor visibility conditions or in tunnels).
9