Cleaning Accessories (Optional Extras) - EdilKamin ADRIA Instalación Uso Y Mantenimiento

Tabla de contenido

Idiomas disponibles

The answers are listed below in summary form, for further details see the other pages of this document.

1) What do I need to prepare in order to install the boiler-stoves?

Smoke outlet that is at least 100 mm in diameter.

An air inlet in the room that is at least 80 cm².

¾" G outlet and inlet fitting.

¾" G drains connection for overpressure valve.

¾" G load fitting.

A certified electrical connection with a thermal magnetothermic switch 230V +/- 10% 50 Hz.

(assess the division of primary and secondary circuits).

2) Can the boiler-stove work without water?

NO. Using the boiler-stove without water will damage it.

3) Do BASIC – ESPRIT - MAGIC - PRESTIGE boiler-stoves emit hot air?

NO. Most of the heat is transferred to the water.

Emit a small amount in the installation environment in the form of radiation from the glass hearth. It is advisable in any case to use a

radiator in the same room.

4) Can I connect the inlet and outlet of the boiler-stove directly to a radiator?

NO, just like other boilers, it must be connected to a collector from which the water is then distributed to the radiators.

5) Do boiler-stoves also supply hot sanitary water?

Hot tap water can be produced using our preassembled KITS.

6) Can I discharge the smoke from the boiler-stoves along the wall?

NO, a discharge which is conform with standards (UNI 10683/05) must reach the ridge of the roof, and in any case proper functioning

requires a vertical stroke of at least 1.5 meters; avoiding that in case of power outage or wind, a slight amount of smoke forms in the

installation environment.

7) Do I need an air inlet in the room where it is installed?

Yes, to replenish the air used by the boiler-stove for combustion. The smoke extractor draws the air from the room into the combu-

stion chamber.

8) What settings are required on the boiler-stove display?

The desired water temperature. The boiler-stove will then adjust the power accordingly to obtain or maintain this.

For small systems, a mode can be set that ignites and shuts down the boiler-stove accordingly, as the water temperature is reached.

(contact DEALER for initial start up)

9) How often do I need to clean the combustion chamber?

Before you ignite the boiler-stove, every time, when it is off and cold. AFTER HAVING BRUSHED THE EXCHANGER PIPES and

moved the smoke duct cleaning rods (see page 37).

10) Do I need to vacuum the pellet hopper?

Yes, at least once a month when the boiler-stove is not used for some time.

11) Can I burn other fuel apart from pellets?

NO. The boiler-stove has been designed to burn wood pellets that are 6 mm in diameter. Any other material can damage it.

12) Can I ignite the boiler-stove by sending an SMS?

Yes, if the DEALER or an electrician has installed the connection via an optional cable code 621240 to the serial port behind the boi-

ler-stove