CRESTO resq red pro Instrucciones De Operación página 14

The equipment regulates the lowering speed to max. 0.8 m/s. However, with increasing
loads, an increase in the speed must be expected.
Hoist
Descent
mode
mode
NB:
Line slippage during the hoisting procedure.
REASON:
The line was not drawn all the way to the bottom of the line reel during the preliminary
hoist. With the rotation of the reel, the line has been forced outwards because of the
combination of load and too little point pressure, after which the line slips prevent any
hoist action.
REMEDY:
Pull hard up or down on the return line (top or person fitted to equipment) to force it
into the bottom of the reel. Rotate the hand wheel at least once with full tension and
keep an eye on the line's woven marking, which will clearly show if the equipment is
being hoisted. If not, e.g. due to heavy load/wet line, an assisting foot loop on the
return line can be made. By putting a foot into the loop it is possible to hoist with
assisting tension on the return line.
11
© CRESTO AB 2011 vers. 2011 - 3 UK 17.10.2011