Safety Instructions - CRESTO resq red pro Instrucciones De Operación

1. Safety instructions

These operating instructions are the manufacturer's (CRESTO) basic instructions for the
correct use and inspection of:
Equipment use must be in accordance with legal requirements and the manufacturer's
specified training.
1.1 The equipment is solely dimensioned for rescue and evacuation only in
accordance with the equipment's technical data (section 2) and the manufacturer's
(CRESTO) instructions cf. relevant technical standards. Special attention must be
made to section 2: instructions regarding maximum safe work load (SWL).
1.2 All other forms of use, e.g. contractor work, are prohibited and illegal and will
terminate all liable and legal obligations between the user and the manufacturer.
1.3 Service, inspection, repair and training must be carried out in accordance with EN
365:2004 section 4.4, 4.5 and 4.6, etc., and ANSI Z 359.1-2007 section 6.1.2, 6.2.1
and 7.3, etc.
1.4 Section 1.3 concerns the standards' requirements that the named actions and
measures may only be carried out by the manufacturer's (CRESTO) personnel who
are documented as competent, or subcontractor personnel who are documented by
the manufacturer as competent.
1.5 In accordance with the applicable working environment rules and standards, the
safe and responsible use of the equipment requires suitable training, cf. 1.4.
1.6 Equipment users must be in good health and good physical condition. In case of
known disorders, the user must be informed by his or her own doctor of possible
consequences, as conditions such as cardiovascular conditions, diabetes, blood
pressure deviations, epilepsy, and balance problems, etc., can be hazardous to
safety when using the equipment.
1.7 Equipment use must be supported by the company's own accident emergency
procedures related to daily work.
Discrepancy
RESQ RED PRO may be used for teaching/training. Such use exerts higher loads on the
equipment, than normal emergency use would. The producer does not recommend the use
of emergency devices for training use. This is due to the fact that the technical specification
in production is optimised to emergency use only.
Manufacturer and expert:
© CRESTO AB 2011
RESQ RED PRO
CRESTO AB
Lägatan 3
SE-302 63, Halmstad, Sweden
Tel.: +46 (0) 10 45 47 500
Fax: + 46 (0) 10 45 47 501
vers. 2011 - 3 UK 17.10.2011
2