Allegion Schlage NDE80 Instrucciones De Instalación Y Guía Del Usuario página 3

B
Install strike and magnet tray assembly.
Note: If dustbox is included, install first.
CAUTION
Magnet or magnet tray and included strike must
be installed! DO NOT DISCARD!
Magnet
Tray
ANSI Strike
Actual Size
2"
(50mm)
Drill a hole C\v" (19 mm) diameter, 1Z\x" (38 mm) deep
OR
Magnet
T-Strike
See instructions below for
magnet installation.
Actual Size
Door Thickness Adjustment
For " thick doors, NO ADJUSTMENT IS REQUIRED. Continue
L 1C\v
to step 1.
For 1B\," or 2" thick doors, complete the following door thickness
adjustment steps.
A Remove chassis from outside assembly.
Pull lever post and rotate 10 degrees counter-clockwise until adjustment
plate tabs align with cutouts on assembly, then remove chassis from
escutcheon.
B Remove adjustment plate by rotating counter-clockwise.
Remove door thickness insert using pin wrench.
C Reorient and replace door thickness insert.
Door Thickness
1B\,"
2"
Chassis Side View
Door Thickness Insert
Door thickness
insert channel