Smoke hollow DG1100S Manual Del Usuario página 18

25
Hardware Needed:
(2) 1/4-20x5/8" Screws
26
Hardware Needed:
(4) #8-32x5/16" screws
Fig. A 15
Fig. B
Fig. C
18
ASSEMBLY,
Rivnut
21
ENSAMBLAJE
STEP 25:
Place HVR cover in the front
corner of the gas grill cabinet
where the HVR enters and exits
the cabinet. Make sure top of
cover is positioned under the
rivnut shown here.
Attach with (2) screws.
STEP 26:
Attach (4) ignition wires to each
burner electrode (Fig. A).
Tilt burner tubes slightly and
insert through openings in front
wall of cabinet. Make certain that
the tip of each valve is completely
INSIDE the end opening of the
burner tubes (Fig. B).
Fasten burner tubes to the burner
support brackets at the back of
the cabinet (Fig. C).