Smoke hollow DG1100S Manual Del Usuario página 22

33
Hardware Needed:
(1) "R" Pin
Fig. A
33
Tool Needed:
Long Nose Pliers
34
Hardware Needed:
(2) Bolt Pins
Fig. A1
Fig. A2
35
Hardware Needed:
(1) AA Battery
22
ENSAMBLAJE
ASSEMBLY,
34
Fig. B
Fig. B
charcoal lifting crank into the
position as shown here(Fig.A).
crank thread as shown (Fig.B).
Unscrew cap from electronic igniter.
Insert AA battery with the "+" end facing out.
Screw cap back onto igniter. When you press
the button, you should see small sparks
jumping from the electrodes onto all
of the burner tubes and sear burner.
The igniter will light ALL burners when you
open the gas valve and press it.
STEP 33:
Screw damper knob onto
the damper slide. Screw
hole located in the cabinet
Using long nose pliers, insert
"R" pin into the hole on the
11
STEP 34:
Attach back
of warming rack
to gas sidelid with bolts
(Fig. A1) and (Fig. A2).
Attach the front wire legs
into holes on the sides
of the grill in locations
(Fig. B).
STEP 35: