Smoke hollow DG1100S Manual Del Usuario página 20

29
ENSAMBLAJE
ASSEMBLY,
STEP 29:
Hardware Needed:
(2) #8-32x5/16" screws
Detach the sear burner from assembled location. Take
Screws are preassembled with sear burner.
the sear burner igniter wire and slide through the small
opening in the sear burner housing (Fig. A).
Fig. A
Press the igniter wire on to the electrode located on
the bottom of the sear burner (Fig. B).
Tilt the sear burner open tube end down and sllide
through the large opening in the housing and ONTO
and OVER the nozzle end of the gas valve (Fig. C).
Look from underneath the housing and make certain
that the valve tip is INSIDE the burner tube (Fig. D).
Fasten the burner to the bracket at the back wall
of the housing (Fig. E).
Fig. C
Fig. B
16
Fig. E
Fig. D
20