General Notes On Cleaning; Oven Cleaning And Maintenance; Removal And Cleaning Of The Side Racks; Cleaning Of The Interior Glass Door Only - Hoover VISION HOZP9177BI Instrucciones De Uso

5. Oven cleaning and maintenance

5.1 General notes on cleaning

The lifecycle of the appliance can be extended through regular
cleaning. Wait for the oven to cool before carrying out manual cleaning
operations.
WARNING: Never use abrasive detergents, steel wool or sharp
objects for cleaning, so as to not irreparably damage the enamelled
parts. Use only water, soap or bleach-based detergents (ammonia).
GLASS PARTS
It is advisable to clean the glass window with absorbent kitchen towel
after every use of the oven. To remove more obstinate stains, you can
use a detergent-soaked sponge, well wrung out, and then rinse with
water.
OVEN WINDOW SEAL
If dirty, the seal can be cleaned with a slightly damp sponge.
ACCESSORIES
WARNING: Clean accessories with a wet, soapy sponge before
rinsing and drying them: avoid using abrasive detergents.
DRIP PAN
● After using the grill, remove the pan from the oven.
● Pour the hot fat into a container and wash the pan in hot water, using
a sponge and washing-up liquid. Alternatively, you can wash the pan
in the dishwasher or use a commercial oven detergent.
NOTE: If greasy residues remain, immerse the pan in water and
detergent.
WARNING: Never put a dirty pan back into the oven.
5.2 Maintenance

REMOVAL AND CLEANING OF THE SIDE RACKS

1- Remove the wire racks by pulling them in the direction of the arrows
(see below)
2- To clean the wire racks either put them in the dishwasher or use a
wet sponge, ensuring that they are dried afterwards.
3- After the cleaning process install the wire racks in reverse order.

CLEANING OF THE INTERIOR GLASS DOOR ONLY

1. Open the oven door.
2.3.4. Lock the hinges, remove the screws and remove the upper
metal cover by pulling it upwards.
5.6. Remove the glass, carefully extracting it from the oven door (NB:
don't remove any other glass or component).
7. At the end of cleaning or substitution, reassemble the parts in
reverse order.
NOTE: On all glass, the indication "Low-E" must be legible and
positioned on the left side of the door, close to the left-hand lateral
hinge. In this way, the printed label of the first glass will be inside the
door.
1.
3.
5.
7.
LOW-E
EN 13
2.
4.
6.
2
1