Tabla de contenido
Publicidad
SOLAR ENERGY MADE BRIGHTER
The collector should be installed in such a way that rear ventilation is guaranteed - to prevent moisture diffusion
in the collector! When installing on full-surface concrete roof structures, rear ventilation of the collector rear panel
can be achieved for example through installation of vertical wooden battens with a minimum thickness of 15mm.
Steps must be taken to ensure that water and other contaminants such as dust, etc. are prevented from getting
into the collector connections and ventilation holes.
Note
Cleaning
Clean the water drip of the metal frame at least once a year (or more often if necessary) to remove soiling (leaves
etc.).
Warranty
Warranty claim only in conjunction with the supplier's original frost protection and correct installation, commis-
sioning and maintenance. Installation by qualified personnel with strict adherence to the instructions is a prerequi-
site for the justification of claims. Note: Installing solar thermal pannels (collectors) near to coastal regions or in
any other corrosive environment may result in corrusion and corrosion of the absorber. Sonnenkraft doesn't take
any responsibility or liability for such damages if installed in such environment. If required, it is possible to contact
us for a special solar panel which is designed and suitable for such environment.
12
With roof angles < 20°, a corresponding rainproof substructure must be ensured. It is
also advisable to observe related instructions of the roof tile manufacturer.
GB
Montagehinweise
Assembly instructions
Istruzioni di montaggio
Instructions de montage
Instrucciones de montaje
Publicidad
Tabla de contenido
