Location And Assembly - Scotsman CME1356 Indicaciones Para El Uso

Location & Assembly
The air cooled models take room temperature air in from the
front and discharge warm air out the back.
A 150 mm minimum clearance on the back, and both sides
is required for the proper operation and service of the air
cooled model.
Unpacking and Assembly:
Begin with unpacking the ice storage bin. Remove the
carton, and using part of the carton as a cushion, tip the bin
on its back to remove the skid and attach the legs or casters.
Note: Stacked applications may not use casters.
Return the bin to an upright position. Check the bin top
gasket for gaps and tears, fill any in with food grade sealant
prior to placing the ice machine on the bin.
Level the top edge of the bin front to back and left to right.
If the ice machine has not been unpacked, do so now.
Remove the carton from the skid. After removal of the
shipping straps, lift the ice machine off the skid directly onto
the bin.
Note: The machine is heavy! Use a mechanical hoist if
necessary.
Secure the ice machine to the bin with the hardware
provided (two metal straps and 4 bolts).
Locate the Bin Thermostat Bracket and hardware. Retain for
later use.
Cabinet Panel Removal:
Note: The top panel holds the upper edges of the side panels
in place.
1. Remove the front panel by removing the two screws
connecting the front panel to the machine, and then pulling
out at the bottom edge.
2. Lift up at the front edge and push the top panel back until
it releases from the tabs connecting it to the back panel.
3. Remove the screws at the front edge of the left side panel,
and pull forward until it releases from the tabs connecting it
to the back panel.
3