Avid CODE Manual De Usuario página 5

English
6
aliGn and trUe CaliPers
Squeeze the front lever 5 or 6 times, then hold. Compress the lever (with your
hand or a rubber band), then snug the CPS bolts enough to hold the caliper in
place.
Spin the wheel and check for rotor drag. If there is drag, loosen the CPS bolts
and repeat. Once there is no drag, torque the CPS bolts in an alternating fashion
to the specified torque.
Repeat the procedure for the rear brake.
7
adJUst reaCh: Code
Use a 2.5 mm hex wrench to adjust the reach if necessary.
Tip: You can also use the rebound adjuster knob from a
RockShox fork to make this adjustment.
2.5 mm hex reach
adjust screw
8
CODE & CODE 5 User Manual
TORQUE TO:
8-10 N•m
(70-90 in-lb)
(in an alternating fashion)
adJUst reaCh: Code 5
Use a 2 mm hex wrench to adjust the reach if necessary.
One click equals 1 mm of adjustment.
If using twist shifters, it will be necessary to slide the levers
away from the shifters or remove them completely to access
the reach adjustment screw. Re-torque the lever clamp bolts
as noted in Step 5 after adjusting the lever reach.
One "click" of the
2 mm hex reach
adjust screw here...
...equals 1 mm of
adjustment here
95-5015-009-000, Rev.C
CODE & CODE 5 User Manual
8
adJUst Pad enGaGement Point: Code
Now it's time to set the pad contact point exactly where it feels best
for your hand. Experiment, turn the red adjuster knob both ways and
see what different settings feel like. Then, chose the spot that you
prefer. You can change the setting whenever you want.
© SRAM Corporation • 2008
English
IN (clockwise):
The lever will engage later.
OUT (counter-clockwise):
The lever will engage earlier.
9