Publicidad
Idiomas disponibles
Idiomas disponibles
1999 To 2010 Ford Super Duty F-250/F-350 & 2008 To 2010 F-450
Do not install mounting rails over plastic bed liners. Plastic bed liners must be cut out of the
way to provide metal to metal contact. Mounting rails may be installed on spray in liners.
Use only bolts, nuts, and washers supplied to install this kit. All bolts are Grade 5 and nuts are
Grade 5 unless otherwise specified.
These instructions are guidelines only, actual installation is the responsibility of the installer
and the owner. Always measure truck and trailer before installing hitch to be sure that there is
clearance at the cab and at the bumper to allow for turns.
Driver's side
frame rail
Figure 3a
Inside of frame rail
Installation Instructions
1.
Lower and remove spare tire if extra room is needed for the installation.
2.
On 2005 to 2010 Gas Engine Vehicles Only. The vapor tube running along the inside of the driver's side frame rail must be
relocated prior to installing the driver's side bracket. See Figure 3a. Remove the flange nut from the outside of the frame and
keep for later use. See Figure 3b. Rotate the tubes up and out of the way. Install the L-bracket (7) with 1/4" hardware (4)(5)(6),
as shown in Figure 3c. Tighten the L-bracket (7) to the frame, but leave the tube holder loose to aid bracket installation.
3.
On 1999 To 2004 Vehicles Only. Remove the upper emergency brake cable hanger from the frame of the truck and keep the
hardware. See Figure 4a.
Driver's side frame
Brake line
4.
Place the rear mounting rail in the box of the truck. Using your tape measure, center the rail between the weld seams on the
length of the truck box floor and the proper distance from the rear edge of the truck box as illustrated in Figure 5. See page 3 for
mounting the brackets to the rails. See below for mounting the brackets to the frame.
5.
Mark and center punch the holes as per the illustration in Figure 5. Move the rail out of the way and drill each position with a
1/8"drill bit. Warning: When drilling holes be aware of potential risks, such as brake lines and fuel tanks, to vehicle
components and make appropriate safe guards to protect them from damage.
6.
Temporarily position the frame brackets on the outside of the frame and check that the 1/8" drilled holes align with the slots of
the frame bracket. Remove the frame bracket from the vehicle.
7.
Enlarge the 1/8"drilled holes to 9/16" with the step drill. Warning: When drilling holes be aware of potential risks, such as
brake lines and fuel tanks, to vehicle components and make appropriate safe guards to protect them from damage.
z
2011 Cequent Performance Products, Inc.
Installation Instructions
CUSTOM QUICK INSTALL MOUNTING KIT
Existing
flange nut
Vapor
tube
Tube
holder
Retain hardware
Figure 4a
5
4
Driver's side
frame rail
4
6
Figure 3b
Sheet 2 of 21
50082N
Part Numbers:
50082
Existing
flange nut
7
Figure 3c
Figure 4b
5/5/11
Rev. D
Publicidad
