Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS WHEN USING THE 30124 RAIL KIT WITH THE
1999 To 2010 Ford Super Duty F-250/F-350 & 2008 To 2010 F-450
HARDWARE AND INSTALLATION IS THE SAME FOR BOTH THE DRIVERS SIDE AND PASSENGERS SIDE
Do not install mounting rails over plastic bed liners. Plastic bed liners must be cut out of the
way to provide metal to metal contact. Mounting rails may be installed on spray in liners.
Use only bolts, nuts, and washers supplied to install this kit. All bolts are Grade 5 and nuts are
Grade 5 unless otherwise specified.
These instructions are guidelines only, actual installation is the responsibility of the installer
and the owner. Always measure truck and trailer before installing hitch to be sure that there is
clearance at the cab and at the bumper to allow for turns.
Equipment Required:
Fastener Kit: 50082F
Wrenches: 3/4, 7/8, 15/16, 15 mm
Drill Bits: 1/8", 11/16"
Other Tools: Center Punch, Measuring Tape
* 5/8" CARRIAGE
BOLT
Hardware and
installation shown
is the same for the
passengers side.
FRONT OF
TRUCK
* 5/8" CONICAL
WASHER
Driver's side
frame rail
Figure 6A
Inside of frame rail
* fasteners are supplied with part number 30035, 58058, 30095 or 30124.
z
2011 Cequent Performance Products, Inc.
4 BOLT INSTALLATION
* 1-1/4" TUBE
SPACER
* 5/16"
SPACER
* 5/8" NUT
Existing
flange nut
Vapor
tube
Tube
holder
Driver's side
frame rail
Figure 6B
Sheet 5 of 21
Figure 6
FRAME BRACKET
HARDWARE ITEMS LISTED
6
ARE FROM PAGE 1 CHART
4
4
5
Figure 6C
50082N
5/5/11
RAIL
Existing
flange nut
7
LISTED ON PAGE
ONE CHART
Rev. D
Publicidad
