Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL INSTALLATION
Make sure connections are neatly tucked into
1.
the ceiling outlet box.
Slide the canopy (B) up to the mounting
bracket (A) and place the key holes on the
canopy (B) over the loose canopy mounting
screws on the mounting bracket (A). Turn the
canopy (B) clockwise until it locks in place at
the narrow section of the key holes. Make
sure the positioning pin on the mounting
bracket falls into one of two holes on the
canopy (B), and then tighten the two canopy
mounting screws.
2.
Attach the canopy bottom cover (C) to the
canopy (B) by inserting the screw heads into
the key slots in the canopy bottom cover (C)
and rotating it clockwise.
NOTE: Adjust the canopy mounting screws
as necessary until the canopy (B) and canopy
bottom cover (C) are snug.
NOTE: The fan motor assembly is shipped
with rubber packing mounts to prevent
movement during transportation. Remove
the rubber packing mounts from the fan
motor assembly and discard prior to attaching
the blade.
Fasten the blade (G) to the fan motor assembly
3.
(F) by lining up the two slots of the motor and
two tabs on the blade (G).
Tighten the three blade mounting screws with
lock washers already installed in the blade
support plate (with screws and lock washers)
(H).
Repeat this procedure for the remaining
blade (G).
NOTE: Make sure the screws are TIGHT!
Loose blade screws can contribute to
unnecessary hum or wobbly during operation.
1
Positioning
Pin
2
Canopy
Mounting
Screw
3
Remove the
rubber packing
mounts
Tabs
12
Canopy Mounting
Screw
Slots
Screws
Publicidad
