Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL INSTALLATION
1. Make sure connections are neatly tucked
into the ceiling outlet box.
Slide the canopy (B) up to the mounting
bracket (A) and place the key holes on the
canopy (B) over the loose canopy mounting
screws on the mounting bracket (A). Turn the
canopy (B) clockwise until it locks in place
at the narrow section of the key holes. Make
sure the positioning pin on the mounting
bracket falls into one of two holes on the
canopy (B), and then tighten the two canopy
mounting screws.
2. Attach the canopy bottom cover (C) to the
canopy (B) by inserting the screw heads into
the key slots in the canopy bottom cover (C)
and rotating it clockwise.
NOTE: Adjust the canopy mounting screws
as necessary until the canopy (B) and
canopy bottom cover (C) are snug.
3. Attach the blades (G) to the blade arms (H)
using the three blade attachment screws
(BB) and rubber blade washers (CC). Insert
a blade attachment screw (BB) and rubber
blade washer (CC) into the blade arm (H),
but do not tighten. Repeat for the two remaining
screws (BB) and rubber blade washers (CC).
Tighten each screw securely starting with the
center screw. Make sure the blade (G) is
straight. Repeat these steps for the remaining
blades.
Hardware Used
BB
Blade Screw
CC
Rubber Blade Washer
1
Positioning
Pin
2
Canopy
Mounting
Screw
3
x 9
x 9
13
Canopy Mounting
Screw
+
Publicidad
