Publicidad
Idiomas disponibles
Idiomas disponibles
1g. Remove fascia - Using a plastic trim panel tool, remove the fascia starting at the outer edges near wheel wells while gently pulling rearward. Disconnect the wiring
harness near center of fascia, and the wiring harness located on passenger's side behind rear wheel. Set fascia aside.
2. Remove bumper beam – using a 13mm socket, remove (6) flange hex nuts holding the bumper beam to end panel and set aside.
©2018 Horizon Global™ Corp - Printed in Mexico
Sheet 6 of 21
24977NP
07-23-18
Rev. A
Publicidad
