Horizon Global CQT24977 Instrucciones De Instalación página 7

3. Install Hitch and bumper beam – Install hitch and bumper beam onto vehicle aligning holes with (6) existing studs in vehicle end panel. Loosely install the (6)
existing M8 flange hex nuts onto the studs in end panel. See Figure 1.
4. Tighten all M8 CL8.8 fasteners with torque wrench to 20 Lb.-Ft. (27 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
5. Trim fascia - using a tape measure, marker, and aviation snips, measure, mark, and cut a notch in the bottom center of fascia and heat shield
approximately 2-1/2'' tall by 3-1/4" wide area. See Figure 2.
6. Reinstall fascia, taillights, interior panels, and wiring using the original fasteners removed in step 1. Be sure to reconnect all wiring to fascia and taillights.
©2018 Horizon Global™ Corp - Printed in Mexico
2-1/2"
3-1/4"
Sheet 7 of 21 24977NP 07-23-18 Rev. A